I might not be up to date on the standards but I'm at the point where I want to use slightly better switches for the control and rev but cant seem to get the wiring right. If you hold down the trigger without releasing it, the whole clip will empty in a few short seconds. The Elite XD RapidStrike CS-18 is a re-release of the N-Strike Elite RapidStrike CS-18 that was released in 2014 under the N-Strike Elite series. S. (compared to the original Elite version's seventy-five feet), or twenty-seven meters in Europe (compared to the original Elite version's twenty meters).

Remove completely, grind down, or melt off any sharp edges or points on remaining solder away from the switch terminals to avoid punctured insulation on nearby wiring. If you are excited by Rapid Fire technology with a huge clip to pummel your enemies into submission then we recommend The Nerf N-Strike Elite Rapidstrike CS-18 Blaster. What the NIC knows as "trustfires" or "ultrafires" (Li-ion, LiCo chemistry, 14500 or 18650 size cells) are absolutely unsuitable for most nerf applications they are often seen on (really, any nerf applications except low-load lights and electronics) as they cannot supply the necessary current.Instead you can easily see how many shots your have left without even ejecting the clip from the blaster.

The RapidStrike is likely a spiritual successor to the 2009 N-Strike Stampede ECS, due to various similarities between the two blasters, such as its abundance of tactical rails, fully-automatic firing mode, and eighteen dart clip. The clip holds all 18 of the included Elite Darts and it's see-through so you can do instant firepower checks! We will bridge those poles together just as in the Stampede, Vulcan, Swarmfire type applications, and we are only powering a single 130 (or 180, perhaps) pusher motor which has a very low load and average current draw.Around the time of the blaster's release, the official Nerf page on Facebook boasted that the RapidStrike could unload its clip in 5.

I started this site after I became a dad - to learn about all of the new blasters and review and catalogue them - because I wanted to share one of my favorite childhood pastimes with my son -- and now, I fell back in love with the hobby! This time is reported to have come from a Nerf-produced video of the RapidStrike which was officially timed during testing phase, though RapidStrike commercials just round it back off to six seconds. In fact, there are not very many similarities between these two blasters, other than both being motorized blasters from the Elite line.Instead of using a dart drum like the HYperfire, the Nerf Rapidstrike uses a unique 18 dart clip system. Route that front branch toward the cycle control switch and the (still uncut) length of wire down toward the trigger/flywheel switch area. If you were to look at the Nerf Hyperfire and Nerf Rapidstrike blasters side by side, there would be no doubt that these are two completely different blasters. In any case, make sure the switch is wired to brake the motor when the bolt is retracted and power (or coast, for dead center) when the bolt is extended. With a fully automatic system, the Nerf N-Strike Elite Hyperfire can fire darts at the incredible rate of 5 per second.